Mitsubishi Electric NZ2GF-ETB, User Manual

Page: 66 / 254

64
(1) Connecting the Ethernet cable
For Ethernet cables, refer to "Network Components". (

Page 49, Section 5.2.2 (1))
(a) Connection
1.
Turn off the power.
2.
Insert the Ethernet cable connector into the port
until a click sound is heard. Pay attention to the
orientation of the connector.
3.
Turn on the power.
4.
Power on the external device connected to the port.
5.
Check if the LED for the port of the connected
Ethernet cable is on.
The time between the power-on and the LINK/SPEED
LED turning on may vary. The LINK/SPEED LED
usually turns on in a few seconds. Note, however, that
the time may be extended further if the linkup process is
repeated depending on the status of the device on the
line.
If the LINK/SPEED LED does not turn on, refer to the
troubleshooting section and take corrective actions.
(

Page 142, CHAPTER 9)
Port for CC-Link IE Field Network
connection Port for Ethernet
connection
On
On