Mitsubishi Electric NZ2GF-ETB, User Manual

Page: 33 / 254

31
CHAPTER 3 SPECIFICATIONS
3
3.
2 Per
form
ance Spec
ificat
io
ns
3.2.1
Performance specifications of each part
The performance specifications of each part of the Ethernet adapter module are described below.
(1) Power supply part
Item Specification
Input voltage (

Page 32, Section 3.2.1 (1) (a)) 24VDC (-35% to +30%)
Current consumption 0.6A
Inrush current (

Page 32, Section 3.2.1 (1) (b)) 100A, 1ms or less
Allowable momentary power failure time ( 
Page 32, Section 3.2.1 (1) (c))
10ms or less
Withstand voltage
510V AC/min (Altitude: 0 to 2000m)
Between the combined "line input/LG terminals" and the "FG terminal and output"
Insulation resistance
10M

or higher by 500VDC insulation resistance tester
Between the combined "line input/LG terminals" and the "FG terminal and output", the
line input and LG terminals, the output and FG terminals
Noise immunity
• By noise simulator of 500Vp-p noise voltage, 1

s noise width, and 25 to 60 Hz
noise frequency
• Noise voltage IEC 61000-4-4, 2kV
Operation status indicator LEDs (Normal: On (green), Error: Off)
Fuse Built-in (not replaceable)
Terminal screw size M3.5
Applicable wire size
0.75 to 2 mm
2
Applicable solderless terminal
RAV1.25-3.5, RAV2-3.5, 0.8mm or less in thickness, Two solderless terminals can be
connected to one terminal.
Applicable tightening torque 0.66 to 0.89N

m
Power supply part Ethernet part
CC-Link IE
Field Network part