OPERATING PROCEDURE
PHOTOS
1. Removing the panel
(1) Remove the screw caps on the panel and remove the
screws of the panel.
(2) Pull the panel slightly toward you, and then remove the
panel by pushing it upward.
34
11-1. MSZ-HJ25VA MSZ-HJ35VA MSZ-HJ50VA
NOTE:
Turn OFF the power supply before disassembly.
Photo 1
Screws of the panel
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
11
DISASSEMBLY INSTRUCTIONS
Horizontal vane
Front panel
OBH647D
