7
en
3.4. Fan speed setting
Cool
Room
Auto
Set temp.
Mode
Temp.
Fan
Fri
28.5
F1
F2
F3
F4
Press the [F4] button to go through the fan speeds in the following order.
Auto
•
The available fan speeds depend on the models of connected indoor
units.
Notes:
●
The number of available fan speeds depends on the type of unit
connected.
●
In the following cases, the actual fan speed generated by the unit
will differ from the speed shown the remote controller display.
1. While the display is in “Standby” or “Defrost” states.
2. When the temperature of the heat exchanger is low in the heat
-
ing mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the tem
-
perature setting.
4. In COOL mode, when room temperature is lower than the tem
-
perature setting.
5. When the unit is in DRY mode.
3. Operation
3.5. Airflow direction setting
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Operation
Main
Main menu
F1
F2
F3
F4
<Item selection>
Main
Main menu
Initial setting
F1
F2
F3
F4
<Exiting the Main menu screen>
Cool
Room
Auto
Set temp.
Mode
Temp.
Fan
Fri
F1
F2
F3
F4
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will
be lost.
<Display of unsupported functions>
Title
Not available
Unsupported function
Return:
F1
F2
F3
F4
Press the [MENU] button on the
Main display.
The Main menu will appear.
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
The message at left will appear
if the user selects a function not
supported by the corresponding
indoor unit model.
3.3. Temperature setting
<Cool, Dry, Heat, and Auto>
28
Cool
Room
Auto
Set temp.
Mode
Temp.
Fan
Fri
Example display
(Centigrade in 1-degree increments)
28.5
F1
F2
F3
F4
Cool
Room
Auto
Set temp.
Mode
Temp.
Fan
Fri
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
•
Refer to the table on 3-1 for the settable temperature range for different
operation modes.
•
Preset temperature range cannot be set for Fan/Ventilation operation.
•
Preset temperature will be displayed either in Centigrade in 0.5- or
1-degree increments, or in Fahrenheit, depending on the indoor unit
model and the display mode setting on the remote controller.
Refer to “Function settings” in the installation manual for the 14 °C Cool-
ing setting.
GG79D031H01_01en.indd 7
2021/04/13 15:46:29
008
