11
en
3.6. 3D i-see Sensor setting
Note:
This function cannot be set depending on the outdoor unit to be
connected.
3.6.1 3D i-see Sensor setting
3
Select “3D i-See sensor” with the
[F1] or [F2] button, and press the
[SELECT] button.
1
Select “Operation” from the Main
menu, and press the [SELECT]
button.
Operation
Main
Main menu
F1
F2
F3
F4
4
Select the desired menu with the
[F1] or [F2] button, and press the
[SELECT] button.
• Air distribution
Select the airflow direction control
method when the airflow direction
is set to “Auto”.
• Energy saving option
Operates the energy-save mode
according to whether persons are
detected in the room by the 3D
i-see Sensor.
• Seasonal airflow
When the thermostat turns off, the
fan and the vanes operate accord-
ing to the control settings.
2
Select “Comfort” from the
Operation menu, and press the
[SELECT] button.
Cursor
Operation
Vane·3D i-See·Vent. (Lossnay)
High power
Comfort
Main menu:
F1
F2
F3
F4
Comfort
Cursor
Manual vane angle
3D i-See sensor
Setting display:
F1
F2
F3
F4
3D i-See sensor
Cursor
Setting display:
Air distribution
Energy saving option
Seasonal airflow
F1
F2
F3
F4
3. Operation
1
First, confirm by setting “Ref.
address” to 0 and “Unit No.” to 1.
• Move the cursor to “Ref. address”
or “Unit No.” with the [F1] button
to select.
• Select the refrigerant address and
the unit number for the units to
whose vanes are to be fixed, with
the [F2] or [F3] button, and press
the [SELECT] button.
• Ref. address: Refrigerant address
• Unit No.: 1, 2, 3, 4
Press the [F4] button to confirm
the unit.
2
Change the “Unit No.” in order
and check each unit.
• Press the [F1] button to select
“Unit No.”.
Press the [F2] or [F3] button to
change the “Unit No.” to the unit
that you want to check, and then
press the [F4] button.
• After pressing the [F4] button, wait
approximately 15 seconds, and
then check the current state of the
air conditioner.
→ The vane is pointing down
-
ward. → This air conditioner is
displayed on the remote control-
ler.
→ All outlets are closed. →
Press the [RETURN] button and
continue the operation from the
beginning.
→ The messages shown to the
left are displayed. → The target
device does not exist at this refrig-
erant address.
• Press the [RETURN] button to
return to the initial screen.
3
Change the “Ref. address” to the
next number.
• Refer to step
1
to change the
“Ref. address” and continue with
the confirmation.
Manual vane angle
Input display:
Cur.
Address
Check
Ref. address
Unit No.
Identify unit Check button
F1
F2
F3
F4
■
Confirmation procedure (wired remote controller)
Manual vane angle
Return:
No communication
Check Unit state.
F1
F2
F3
F4
Manual vane angle
Return:
Ref. address
Unit No.
Function setting for unit
with vane fully open.
F1
F2
F3
F4
GG79D031H01_01en.indd 11
2021/04/13 15:46:35
012
