Mitsubishi Electric MELSERVO-J4 series, Instruction Manual

Page: 329 / 646

11 OPTIONS AND PERIPHERAL EQUIPMENT
11.1 Cable/connector sets
327
11
11
OPTIONS AND PERIPHERAL EQUIPMENT
We recommend using HIV wires to wire the servo amplifiers, options, and peripheral equipment. Therefore,
the recommended wire sizes may differ from those used for the previous servo amplifiers.
11.1
Cable/connector sets
The IP rating indicated for cables and connectors is their protection against ingress of dust and raindrops
when they are connected to a servo amplifier or servo motor. If the IP rating of the cable, connector, servo
amplifier and servo motor vary, the overall IP rating depends on the lowest IP rating of all components.
Please purchase the cable and connector options indicated in this section.
WARNING
• Before connecting any option or peripheral equipment, turn off the power and wait for 15 minutes or more until the charge lamp turns off. Then, confirm that
the voltage between P+ and N- is safe with a voltage tester and others. Otherwise, an electric shock may occur. In addition, when confirming whether the
charge lamp is off or not, always confirm it from the front of the servo amplifier.
CAUTION
• Use the specified peripheral equipment and options to prevent a malfunction or a fire.