Mitsubishi Electric MELSENSOR VS70 Series, User Manual

Page: 60 / 112

58
6 SYSTEM CONSTRUCTION
6.3 Attachment of a Lens and Light
Attachment of a C-mount lens and an illumination accessory
Attach a C-mount lens and an illumination accessories in the light cover set including illumination with LED ring light by
following the procedure below.
Precautions
• Before attaching or removing an illumination accessory, turn the power of the vision sensor OFF.
Failure to do so may result in damage to the vision sensor and/or the illumination accessory.
• A connector protrudes from the underside of the light housing and can be damaged if placed on a hard surface.
• A connector protrudes from the underside of the light housing.
To prevent damage, it is recommended the light housing not be removed from the box until ready to be assembled.
• Wear gloves when attaching a filter to prevent leaving fingerprints on the surface of the filter.
• When removing a PCB from a vision sensor, refer to the following section to safely remove the PCB and avoid damage to
the vision sensor.

Page 91 Removal of a PCB
• The maximum insertion depth of the M3 screws is 3.5 mm in the rear housing, and 3.75 mm in the front housing, plus the
thickness of the mounting material used.
Operating procedure
1.
Remove the rubber faceplate covering the image sensor window.
2.
Remove the protective film covering the threaded lens opening (if present).
3.
Plug a PCB into the lighting connector on the vision sensor faceplate.
PCB