Mitsubishi Electric MELSEC Q80BD-J71GF11-T2, User Manual

Page: 58 / 248

56
4 PROCEDURE BEFORE OPERATION
4.7 Tests After Wiring
Communication test
Communication test checks if transient transmission data can be properly routed from the own station to the communication
target.
Take the following system configuration as an example of communication test procedure.
Operating procedure
1.
Start Utility on the computer where CC-Link IE Field
Network board is installed.
2.
Set the routing parameters on the "Routing Parameter
Setting" screen as shown in the figure to left.
(

Page 108 Routing parameters)
3.
Write the network parameters being set to the CC-Link
IE Field Network board.
[Online]  [Write to Board]
4.
Reset the board.
[Online]  [Reset operation]
5.
Open the "Communication Test" screen and set data to
"Communication Destination Setting" and
"Communication Data Setting".
[Diagnostics]  [CC IE Field Diagnostics] 
[Communication Test] button
CC-Link IE
Field Network
CC-Link IE
Field Network
CC-Link IE
Field Network
Network No.1
Network No.2
Network No.3
Station
No.2
Station
No.0
Station
No.0
Station
No.0
Station
No.1
Station
No.1
Station
No.2
Station
No.2
Station
No.3
Station
No.4
Own station
(request source)
Communication
target
(Relay
station 1) (Relay
station 2)
Station
No.3
Routing parameters for stations of network No.1
Routing parameters for stations of network No.2
Routing parameters for stations of network No.3
No setting is required for station
No.3 because data are transmitted
via the station itself.
No setting is required for station
No.0 because data are transmitted
via the station itself.
No setting is required for station
No.2 because data are transmitted
via the station itself.
No setting is required for station
No.3 because data are transmitted
via the station itself.