Mitsubishi Electric MELSEC Q80BD-J71GF11-T2, User Manual

Page: 103 / 248

10 SETTING PARAMETERS
10.2 Setting Network Parameter
101
10
Network configuration setting
Set parameters of slave stations (slave station points, link device assignment) to the master station, and set link scan mode
and block data assurance per station.
This setting is available when "CC IE Field (Master Station)" is selected in the network setting.
Window
[View]  [Network Parameter]  "CC IE Field Number of Boards Setting" screen  "Network Configuration Setting"
Operating procedure
1.
Set the items on the screen.
Item Description
Assignment Method Select an assignment method for send range of each station.
Number of PLCs Display the number of stations from 1 to total stations.
Station No. Set the station number.
Setting range: 1 to 120
Station Type Select the station type.
RX/RY Setting Points Specify the number of relay points on the link side.
Setting range:
• 16 to 2048 points for "Local Station" and "Intelligent Device Station"
• 16 to 128 points for "Remote Device Station", 16 to 64 points for "Remote I/O Station"
Start Specify the start point of relay on the link side.
Setting range: 0 to 3FF0
End Specify the end point of relay on the link side.
Setting range: F to 3FFF
RWw/RWr Setting Points Specify the number of registers on the link side.
Setting range:
• 4 to 1024 points for "Local Station" and "Intelligent Device Station"
• 4 to 64 points for "Remote Device Station"
Start Specify the start point of register on the link side.
Setting range: 0 to 1FFC
End Specify the end point of register on the link side.
Setting range: 3 to 1FFF
Reserved/Error Invalid Station Set reserved stations and error invalid stations.
Alias Set the alias.
Setting range: Up to 8 characters
Comment Set the comment.
Setting range: Up to 32 characters
[Supplementary Setting] button Displays the "Supplementary Setting" screen. (

Page 102 Supplementary setting)
[Equal Assignment] button Displays the "Equal Assignment" screen. (  Page 103 Equal assignment)
[Identical Point Assignment] button Assigns the same link device points to all local stations.
Enter the points in the field next to the button.