Mitsubishi Electric MELSEC iQ-R C R12CCPU-V, User Manual

Page: 120 / 262

118
6 Ethernet COMMUNICATION FUNCTIONS
6.7 Parameter Settings
6.7
Parameter Settings
This section shows the settings required for communication with a target device in a C Controller module.
Own node settings
Set the own node required for Ethernet communication.
[Module Parameter]  [Basic Settings]  [Own Node Settings]
Window
Displayed items

: No setting
When using both CH1 and CH2, the IP address and subnet mask should be set with different values for CH1
and CH2, respectively.
Item Description Setting range Default
IP Address CH1

Set whether to use the Ethernet port (CH1). • Not Use
• Use Use
IP Address Set the same class and subnet address as the target device to be
communicated with. Set the IP address so that CH1 belongs to the
different network from CH2. • 0.0.0.1 to
223.255.255.254
192.168.3.3
Subnet Mask Set the subnet mask pattern of the default gateway when IP
address of the default gateway is set and perform communication
with a target device on another network via a router.
All the devices on a sub network should have the same subnet
mask. This setting is not required for communication in a single
network. • 128.0.0.0 to
255.255.255.252
255.255.255.
0
Default Gateway Set the IP address for the device (default gateway) which is
relayed for the access to the target device on other network.
Set the value that satisfies the following conditions.
• The IP address class is any of A, B, and C.
• The subnet address of the default gateway is the same as that
of the C Controller module on the own station.
• The host address bits are not all '0' or all '1'.
•

(Blank)
• 0.0.0.1 to
223.255.255.254

CH2

Set whether to use the Ethernet port (CH2). • Not Use
• Use Not Use
IP address Same as CH1 • 0.0.0.1 to
223.255.255.254

Subnet Mask • 128.0.0.0 to
255.255.255.252
Default Gateway •

(Blank)
• 0.0.0.1 to
223.255.255.254