3. Setting
33
3.7.
Setting Menu 4
: LCD Settings (Setting Model Display, Version Display, Backlight, and
Display Update Time)
This section is for confirming the model, option code and the product version, and also set the backlight and the display
update time.
In the operation mode, press
+
simultaneously for 2 seconds or more, and the following operation
becomes available.
SET
RESET
Set the setting menu number to “4”.
(as shown in the right figure)
Setting menu
The display update time for the measured value can be change.
If the display switches too quickly for you to read the displayed
value, set it to 1.0 second.
(Normally, leave this setting to 0.5 second.)
0.5second
1second
⑤
Display update
time
The backlight can be set to continuous on (HoLd)
or auto off (Auto).
④
Backlight auto off
Auto
HoLd
<When auto off (Auto) is selected>
No button operation for 5 minutes
→
the backlight turns off
Button operation during off (Note)
→
the backlight turns on
for 5 minutes
Note: When the backlight is off, pressing any
button once does not switch the display but only
turns on the backlight.
Pressing any button again switches the display.
(Auto off)
(Continuous on)
The backlight brightness can be adjusted.
③
Backlight brightness
1
2
3
4
5
Dark
Bright
The product version can be checked.
(The product version is displayed, but cannot be changed.)
②
Version display
The model can be confirmed. (This is only display, and settings cannot be changed.)
（
1
）
Middle Line
Model
ME96SSRA-MB
（
2
）
Lower Line
Option code
Blank
ME-4210-SS96
ME-0040C-SS96
ME-0052-SS96
ME-0000MT-SS96
ME-0000BU-SS96
①
Model + option cod
e
*1 If “E90xx” appears,
MODBUS®TCP communication
error will be occurred.
SET
DISPLAY
SET
DISPLAY
SET
DISPLAY
SET
DISPLAY
SET
SET
DISPLAY
According to the setting flow (page 16 to 21), save the changed
contents, or continue to the other setting menu.
Setting Menu
