Mitsubishi Electric ME96SSEB-MB, User Manual

Page: 17 / 100

16
3. How to Set up
Setting Flow
For measurement, you must set settings such as phase wire system, VT/Direct voltage, and CT primary current
in the setting mode.
From the operating mode, enter the setting mode and then set necessary items. Any items not set remain in the
factory default settings.
For normal use, only set up the items in the setting menu 1. For details on the settings, refer to
3.2 .
For details on the factory default settings, refer to 8.4 .
CAUTION
The setting change provides the initialization of the related setting items and
measured data. Therefore, check that beforehand. For details, refer to
3.11
Initialization of Related Items by Changing a Setting .
Measurement
screen Setting Menu End
End screen
CANCEL
screen
Automatic shift
Demand
current
time period
CT current
VT/Direct
voltage
Display
pattern
Phase wire
system
Setting Menu 1 Setting Menu 2 Setting Menu 3
Cancel the
settings
Save the
settings
Instrument restart
or
Factory default
settings
*2
*1
Password protection
screen
Example of
Setting Mode
Example of Setting
Confirmation Mode
Active/Reactive
energy
measurement
Harmonics
display
Change
the
password
MODBUS
RTU
Address
MODBUS
RTU
Parity
MODBUS
RTU
Stop bit
MODBUS
RTU
Baud rate
Operating Mode
ON
Blink