TM_i-BX(-N)_NC05_00_06_20_EN
MEHITS S.p.A.
●
TECHNICAL MANUAL
Version NC05 - Translation of the Original Instructions
8
2
USER INTERFACE
2.1
USER TERMINAL
The interface that can be used with the controller is a pLDPRO interface with graphic display.
The connected
pLDPRO interface does not have a sensor. Therefore, it can only guarantee unit control.
pld-PRO interface (on board of the unit):
2.1.1
BUTTONS GENERAL FUNCTIONS
Key
Description
[PRG key]: to access the main menu
[UP key]: moves around the masks and sets control parameter values
[DOWN key]: to navigate through the screen and set the control parameter values
[ENTER key]: to confirm the data entered
[ESC key]: goes back one level in the mask tree if you are in the header masks, or returns to the main
mask.
[ALARM button]: displays the alarms and resets normal operating conditions.
2.2
GENERAL CHARACTERISTICS OF THE INTERFACE
2.2.1
PASSWORD MANAGEMENT
By entering a numeric password it is possible to access four menu levels. The access levels are as follows:
•
“User” password, for the standard user. 00 menu
access.
•
• “Installer” password, for the installer of the unit. 00, 01, 02, 03, 04, 06, 07, 09 menu access
•
“Service” password, for maintenance and assistance operators. 00, 01, 02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12 menu access
•
• “Factory” password, for
the sole and exclusive use of manufacturer’s personnel (not to be disclosed externally). Access to all menus:
00, 01, 02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14
To enter the password, type every single digit in the set order from left to right.
To move from one digit to the next press [ENTER].
If the cursor should be on the first digit to the left, then this brings back to the main window.
The following table shows the values of the “User”, “Installer” and “Service” passwords:
USER PASSWORD
INSTALLER PASSWORD
SERVICE PASSWORD
0012
0034
0738
