Mitsubishi Electric GT15, Connection Manual

Page: 434 / 864

12 - 14
12. CC-Link IE FIELD NETWORK CONNECTION
12.4 PLC Side Setting

Unit parameter settings of System
configuration (Network Type: CC IE Field)
(1) [Module parameter] of CW Configurator
(a) Module parameter
: Necessary : As necessary : Not necessary
*1 Specify the same network No. as that of the GOT.
(b) Network Configuration Settings
: Necessary : As necessary : Not necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
(1) When changing the unit parameter
After writing unit parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset
the PLC CPU.
(2) GOT station type
Set the GOT as an intelligent device station.
Item Set value
Setting
necessity at
GOT connection
Station type Master station (fixed)
Network No.
*1
1
Station No. 0 (fixed)
Parameter setting Parameter
Channel No. (Use default value)
Network Configuration
Settings
Refer to (b)
Item Set value
Setting necessity
at GOT
connection
Rx/RY,
RWw/RWr
Setting (1)
*1
Rx/RY
setting Station
No.1
Start 0000
H
End 00FF
H
RWw/RWr
setting
Station
No.1
Start 0000
H
End 00FF
H
Reserved/Error Invalid Station No setting