Mitsubishi Electric GOT SIMPLE Series, User Manual

Page: 49 / 310

6 INSTALLATION
6.1 Control Panel Inside Dimensions for Mounting GOT
47
6
6
INSTALLATION
6.1
Control Panel Inside Dimensions for Mounting
GOT
Mount the GOT onto the control panel while considering the following control panel inside dimensions.
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points upward.
Applicable cable
Some cables may need to be longer than the specified dimensions when connecting to the GOT. Therefore,
consider the connector dimensions and bending radius of the cable as well for installation.
MOUNTING PRECAUTIONS
WARNING
• Be sure to shut off all phases of the external power supply used by the system before mounting or removing the GOT
main unit to/from the controller.
Not doing so can cause the unit to fail or malfunction.
MOUNTING PRECAUTIONS
CAUTION
•
•
•
•
• Tighten the mounting screws within the specified torque range.
Undertightening can cause the GOT to drop, short circuit or malfunction. In addition, undertightening can disable
waterproof or oil proof effect.
Overtightening can cause a drop, short circuit or malfunction due to the damage of the screws or the GOT. In addition,
the waterproof effect and oilproof effect may not be available due to the "distortion" of GOT or panel.
Operate and store the GOT in environments without direct sunlight, dust, lamp black, conductive dust, corrosive gas,
combustible gas, high temperature, condensation, wind, rain, vibrations and impacts.
Electric shock, fire, malfunction, product damage or deterioration can be caused.
Connect connection cables securely to the specified connectors while the power is turned OFF.
Imperfect connection may cause malfunction or failure.
Never drop cutting chips and electric wire chips into the ventilation window of the GOT when you drill screw holes or
perform wiring.
Otherwise, fire, failure or malfunction may be caused.
Use the GOT in the environment that satisfies the general specifications described in this manual.
Not doing so can cause an electric shock, fire, malfunction or product damage or deterioration.
Unit: mm(inch)
30(1.18)