Mitsubishi Electric GOT SIMPLE Series, User Manual

Page: 237 / 310

16 GOT SELF CHECK (DEBUG)
16.2 FX List Editor
235
16
Access range
For the FXCPU in Ethernet connection, the GOT can monitor only the host station.
The access range other than the above is the same as the access range when the GOT is connected to a controller.
For details of the access range, refer to the following.

GT Designer3 (GOT2000) Screen Design Manual

GOT2000 Series Connection Manual (Mitsubishi Product) For GT Works3 Version1
Precautions
Using other peripheral equipment for sequence program/parameter change
When using the MELSEC-FX list editor, do not change programs or parameters in the PLC CPU from other peripheral
equipment.
If programs or parameters are changed, exit the MELSEC-FX list editor once and start the MELSEC-FX list editor again.
If the program on one PLC is changed carelessly from multiple units of peripheral equipment (including GOT), the contents of
the program in the PLC CPU and the peripheral equipment may not be the same, resulting in an unintended operation of the
PLC CPU.
Sequence program change
Stop the FX PLC before changing (writing, inserting, deleting) a sequence program or changing parameters.
Operation is not possible with the FX PLC running.
If you press the [GO] key but the system does not proceed to the next operation (for
example, a search)
Check the input contents (applied instruction number, device value, etc.).
When using list monitor
Only devices to be used for basic instructions can be monitored.
The status of devices (word, bit) to be used for application instructions cannot be monitored.