Mitsubishi Electric GOT SIMPLE Series, User Manual

Page: 236 / 310

234
16 GOT SELF CHECK (DEBUG)
16.2 FX List Editor
Specifications
System configuration
This section describes the system configuration of the MELSEC-FX list editor.
For the setting method in each connection form, used communication unit/cable and cautions on connection form, refer to the
following manual.

GOT2000 Series Connection Manual For GT Works3 Version1
Controllers that can be edited with the MELSEC-FX list editor
Target controller
*1:
FXCPU
*1 FX list editor is not applicable to for MELSEC iQ-F series.
Connection forms
This function can be used in the following connection types.
( : Available, : Unavailable)
*1 MELSEC-FX list editor cannot be used when using CC-Link IE field network Ethernet adapter.
*2 Available only when using FX3 series.
Functions list and monitor conditions
The following shows the memory that can be monitored by the MELSEC-FX list editor and the FX PLC status conditions.
( : Can be monitored : Can be monitored under certain conditions : Cannot be monitored)
*1 The operation is available only when the protect switch is OFF.
*2 The available memory differs depending on the FX PLC being used.
For details, refer to the following.

The hardware manual of the FX PLC being used
Function name Connection form between GOT and PLC
Name Description Direct CPU connection Ethernet connection
*1
MELSEC-FX list editor Sequence program writing, parameter setting,
PLC diagnostics and keyword registration, etc.
*2
Function Memory that can be monitored
*2
FX PLC
status Reference
Built-in
memory RAM
memory
cassette EEPROM
memory
cassette,
flash memory
cassette EPROM
memory
cassette
Reading
sequence
programs Displaying sequence
programs RUN/STOP  Page 241 Displaying
sequence programs
Searching commands/
devices  Page 243 Searching
commands/devices
Writing
sequence
programs Writing commands
*1
For Stop only

Page 245 Writing commands
Changing operands/
set values

Page 250 Deleting
commands
Inserting commands  Page 245 Writing commands
Deleting commands  Page 250 Deleting
commands
Sequence program all clear

Page 251 Sequence program
all clear
PLC diagnostics RUN/STOP

Page 252 PLC diagnostics
Parameter setting Display  Page 254 Parameter setting
Setting
*1
For Stop only
Keyword RUN/STOP

Page 256 Keyword