11 - 32
11. CONNECTION TO CHINO CONTROLLER
11.5 Controller Side Setting
11.5.13 Station number setting
Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
(1) Direct specification
When setting the device, specify the station number of
the controller of which data is to be changed.
(2) Indirect specification
When setting the device, indirectly specify the station
number of the controller of which data is to be changed
using the 16-bit GOT internal data register (GD10 to
GD25).
When specifying the station No. from 100 to 115 on GT
Designer3, the value of GD10 to GD25 compatible to
the station No. specification will be the station No. of
the controller.
(3) All station specification
Target station differs depending on write-in operation or
read-out operation.
• For write-in operation, all station will be a target.
• For read-out operation, only one station will be a
target.
• All station specification is not available for KE3000.
Do not use the all station specification for systems
which include KE3000.
Model name
Specification
range
Refer to
LT230, LT300, LT400, LT830
1 to 99
DZ1000, DZ2000
1 to 31
DB1000, DB2000
1 to 99
GT120
1 to 95
KP1000, KP2000
1 to 99
AL3000, AH3000
1 to 31
SE3000
1 to 31
JU
1 to 99
KE3000
1 to 31
LE5000
1 to 99
Specification
station NO.
Compatible
device
Setting range
100
GD10
1 to 99: LT230, LT300, LT400, LT830
DB1000, DB2000, KP1000,
KP2000, JU, LE5000
1 to 31: DZ1000, DZ2000, AL3000
AH3000, KE3000, SE3000
1 to 95: GT120
For the setting other than the above, error
(dedicated device is out of range) will occur.
101
GD11
102
GD12
103
GD13
104
GD14
105
GD15
106
GD16
107
GD17
108
GD18
109
GD19
110
GD20
111
GD21
112
GD22
113
GD23
114
GD24
115
GD25
GOT
Station
No.3
Station
No.7
Station
No.1
Station
No.15
Station
No.6
Examples of station number setting
Summary of Contents for GOT 1000 Series
