149
Function assignment of external terminal and control
4.11.9 Pulse train output of output power (Y79 signal, Pr. 799)
(1) Pulse increment setting for output power (Y79 signal,
Pr.799
)
After power ON or inverter reset, output signal (Y79 signal) is output in pulses every time accumulated output power
of the inverter exceeds
Pr.799 Pulse increment setting for output power
.
The inverter continues to count the output power at retry function or when automatic restart after instantaneous
power failure function works without power OFF of output power (power failure that is too short to cause an inverter
reset), and it does not reset the count.
If power failure occurs, output power is counted from 0kWh again.
Assign pulse output of output power (Y79: setting value 79 (positive logic), 179 (negative logic)) to
Pr.190 or Pr.192
(Output terminal function selection)
.
After power ON or inverter reset, output signal (Y79 signal) is output in pulses every time accumulated output power,
which is counted after the
Pr.799
Pulse increment setting for output power
is set, reaches the specified value (or its integral
multiples).
Parameter
Number
Name
Initial
Value
Setting Range
Description
799
Pulse increment setting for
output power
1kWh
0.1kWh, 1kWh, 10kWh,
100kWh, 1000kWh
Output signal is output in pulses at every output
power (kWh) that is specified.
The above parameters can be set when
Pr. 160 Extended function display selection
= "0".
NOTE
Because the accumulated data in the inverter is cleared when control power is lost by power failure or at an inverter
reset, the value on the monitor cannot be used to charge electricity bill.
Changing the terminal assignment using
Pr. 190 and Pr. 192 (output terminal function selection)
may affect the other
functions. Set parameters after confirming the function of each terminal.
(
)
REMARKS
When parameter copy is performed,
Pr.799
= "9999" might be set. However, the inverter operates as
Pr.799
were at
"1kWh" (initial value) in such case.
Parameters referred to
Pr. 190, Pr. 192 (output terminal function selection)
When
Pr.799
= 10
10kWh
20kWh
Time
OFF
ON
ON for 0.15s (0.1 to 0.2s)
Output power
Pulse output of output power
(Y79)
Summary of Contents for FR-F700PJ Series
