Mitsubishi Electric fr-e700 series, Instruction Manual

Page: 432 / 608

Communication operation and setting Parameter
6 - 278
햲
The signal within parentheses is the default setting. The description changes depending on the
setting of Pr. 180 to Pr. 184 "Input terminal function selection". (Refer to section 6.10.1.) Each
assigned signal is valid or invalid depending on NET. (Refer to section 6.18.3.)
햳
The signal within parentheses is the default setting. Definitions change according to the Pr. 190
to Pr. 192 "Output terminal function selection". (Refer to section 6.10.5.)
The restrictions depending on the operation mode changes according to the computer link
specifications.
Bit
Definition
Control Input Instruction Inverter Status
0 Stop command
RUN (inverter running)
햳
1 Forward rotation command Forward rotation
2 Reverse rotation command Reverse rotation
3
RH (high speed operation command)
햲
SU (up to frequency)
4
RM (middle speed operation command)
햲
OL (overload)
5
RL (low speed operation command)
햲
0
6 0
FU (frequency detection)
햳
7 RT (second function selection)
ABC (Alarm)
햳
8 AU (current input selection) 0
9 0 0
10
MRS (output stop)
햲
0
11 0 0
12
RES (reset)
햲
0
13 0 0
14 0 0
15 0 Alarm
Tab. 6-101: Inverter status/control input instruction
Operation Mode Read Value Written Value
EXT H0000 H0010
PU H0001 —
EXT JOG H0002 —
PU JOG H0003 —
NET H0004 H0014
PU + EXT H0005 —
Tab. 6-102: Operation mode/inverter setting