15
2
(2) Wire the shielded twisted pair cable after stripping its sheath to make its cables loose.
Also, protect the shielded cable of the shielded twisted pair cable to ensure that it will
not make contact with the conductive area.
Strip off the sheath for the below length. If the length of the sheath peeled is too long, a
short circuit may occur with neighboring wires. If the length is too short, wires might
come off.
Wire the stripped cable after twisting it to prevent it from becoming loose. In addition,
do not solder it.
Use a blade terminal as necessary.
When using the blade terminal, use care so that the twisted wires do not come
NOTE
• Blade terminals commercially available (as of February 2012. The product may be changed without notice.)
Cable stripping length
Terminal
Screw Size
Wire Size (mm
2
)
Blade Terminal Model
Manufacturer
Blade terminal
crimping tool
with insulation sleeve
without insulation sleeve
M2
0.3 to 0.5
Al 0,5-6WH
A 0,5-6
Phoenix Contact
Co.,Ltd.
CRIMPFOX 6
0.75 (for two wires)
Al-TWIN 2
0,75-10GY
―
Sheath
Shield
(perform protective treatment)
Twisted pair shielded cable
5 mm
Crumpled tip
Wires are not inserted
into the sleeve
Unstranded
wires
Damaged
Wire
W
ire
Sleeve
Sl
ee
ve
0 to 0.5mm
0 t
o 0
.5m
m
A8AP.book 15 ページ ２０１３年９月１２日 木曜日 午後７時４８分
