Mitsubishi Electric FR-A820-00046 (0.4K), Instruction Manual, Page: 204 / 1218

Parameter List Parameters
5 - 2
5.1 Parameter List
5.1.1 Parameter list (by number)
For simple variable-speed operation of the inverter, the initial value of the parameters may be used as
they are. Set the necessary parameters to meet the load and operational specifications. Parameter set-
ting, change and check can be made from the operation panel and the parameter unit.
NOTES
indicates simple mode parameters. Use Pr. 160 "User group read selection" to switch
between the simple mode and extended mode (initially set to extended mode).
Parameter setting may be restricted in some operating statuses. Use Pr. 77 "Parameter write selec-
tion" to change the setting.
Refer to Appendix A.3 (page A-5) for instruction codes for communication and availability of
parameter clear, all clear, and parameter copy of each parameter.
Fu
n
c
ti
o
n
Pr.
Pr.
group
Name Setting range
Minimum
setting
increments
Initial value
Refer
to page
Cu
st
o
m
e
r
setting
FM CA
Basic fu
nc
tio
n
s
0 G000
Torque boost
0 to 30% 0.1%
6%
5-688
4%
3%
2%
1%
1 H400
Maximum frequency
0 to 120 Hz 0.01 Hz
120 Hz
5-321
60 Hz
2 H401
Minimum frequency
0 to 120 Hz 0.01 Hz 0 Hz 5-321
3 G001
Base frequency
0 to 590 Hz 0.01 Hz 60 Hz 50 Hz 5-690
4 D301
Multi-speed setting (high speed)
0 to 590 Hz 0.01 Hz 60 Hz 50 Hz 5-197
5 D302
Multi-speed setting (middle speed)
0 to 590 Hz 0.01 Hz 30 Hz 5-197
6 D303
Multi-speed setting (low speed)
0 to 590 Hz 0.01 Hz 10 Hz 5-197
7 F010
Acceleration time
0 to 3600 s 0.1 s
5 s
5-241
15 s
$
8 F011
Deceleration time
0 to 3600 s 0.1 s
5 s
5-241
15 s
$
9
H000
C103
Electronic thermal O/L relay
Rated motor current
0 to 500 A
0.01 A
Inverter rated
current
5-303,
5-72,
5-471
0 to 3600 A
0.1 A
DC inj
e
ction
bra
k
e
10 G100 DC injection brake operation frequency 0 to 120 Hz, 9999 0.01 Hz 3 Hz 5-701
11 G101 DC injection brake operation time 0 to 10 s, 8888 0.1 s 0.5 s 5-701
12 G110 DC injection brake operation voltage 0 to 30% 0.1%
4%
%
5-701
2%
%
1%
%
Tab. 5-2: Parameter overview (by number) (1)
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple
Simple Simple Simple