Mitsubishi Electric F920GOT-BBD-K-E, Hardware Manual

Page: 136 / 592

GOT-F900 SERIES (CONNECTION) Installation and Wiring of Handy GOT 5
5-34
5.9 Wiring and Handling of Operation Switches SW1 to SW4
This section explains the wiring and the use of the operation switches and the grip switch as well as
control of the LEDs for confirming pressing of the switches.
5.9.1 Handling of operation switches
This section explains the use of the operation switches and control of the LEDs for confirming pressing
of the switches.
The switches should be wired by the user. LED indication is executed through communication.
1) Wiring the operation switches
The operation switches are assigned as follows, and connected to the PLC through an external
cable.
Connection example
Pin layout
In the wire colors of the F9GT-HCAB1-
"
M, the indication "Color 1/Color 2" indicates striped two
colors.
2) Input of operation switches
Use the operation switches of the Handy GOT as follows.
How to use the operation switches
Because the operation switches SW1 to SW4 are directly connected to inputs of the PLC, they can
be controlled freely by programs in the PLC in the same way as general inputs.
- An operation switch is taken into the PLC as a momentary type switch with N/O contact.
- When you would like to treat input of an operation switch as N/C contact or an alternate type
switch, create a proper program in the PLC.
Signal name
External cable Conversion box
F9GT-HCAB-
" " " "
M F9GT-HCAB1-
" " " "
M F9GT-RHCAB-
" " " "
M F9GT-HCNB
SW-COM 14 Fresh green 12 SWCOM
SW1 15 Sky blue 13 SW1
SW2 16 Black/white 14 SW2
SW3 17 Red/white 15 SW3
SW4 18 Green/white 16 SW4
P L C
c o m m o n
0 V
X 0 X 1 X 2
1 6 1 5 1 4
X 4 X 3 X 5
S W 1
S W
1 8 1 7
S W 2 S W 3 S W 4
H a n d y G O T
X0
Y0
Example:
When a switch is wired to X0 of the PLC
ON
OFF
ON
OFF
Operation of
operation switch
X0