Mitsubishi Electric E1061, Installation Manual

Page: 14 / 25

Chemical Resistance
Solvent Resistance
Autotex F157/F207 withstands exposure of more than 24 hours duration under
DIN 42 115 Part 2 to the following chemicals without visible change:
Acetonitrile Diesel Downey / Lenor
1
Phosphoric acid (<30%)
Ajax / Vim in solution Ethanol Potassium ferricyanide
Alkalicarbonate solution 1 Glycerine Potassium hydroxide
(<30%)
Ammonia (<40%) 1 Glycol Pure Turpentine
Acetic acid (<50%) Gumption
1
SBP 60/95
1
Ariel powder in solution
1
Hydrochloric acid (<36%) Sulfuric acid (<10%)
Bleach 1 Linseed oil Tomato ketchup
Castor oil Methanol Trichloroacetic acid
(<50%)
Caustic soda (<40%) 1 Nitric acid (<10%) White Spirit
Cutting oil Paraf fi n oil Windex
1
Cyclohexanol Persil powder in solution
1
Wisk
Diacetone alcohol Petroleum spirit 1 -
1
Extremely faint glossing of the texture was noted.
Autotex withstands DIN 42 115 Part 2 exposure of up to 1 hour duration to glacial
acetic acid without visible change.
Autotex is not resistant to high pressure steam at over 100 °C or the following
chemicals:
Concentrated mineral acids Benzyl alcohol
Concentrated caustic solution Methylene chloride
Outdoor Use
In common with all polyester based films Autotex F157/F207 is not suitable for
use in conditions of long term exposure to direct sunlight.
4.2.2 Touch Screen Surface
The touch screen surface on the operator panel withstands exposure to the
following solvents without visible change:
Solvents Time
Acetone 10 minutes
Isopropanol 10 minutes
Toluene 5 hours
Mitsubishi Electric, MA00815F 14