Mitsubishi Electric CR800 Series, Special Specifications Manual, Page: 82 / 156

3-69
Outside dimensions/Installation dimensions
3 Controller
3.3.2 Installation dimensions
(1) Controller
The following figures show the dimensions required installing the controller.
For the placement of the controller on its side (the horizontal installation), two stacks is permitted.
Fig.3-5 ： Installation dimensions
Fixing installation section sure for prevention from the fall, when using the controller
placing vertically. The reference figure of the metal plate for fixing is shown in
Fig. 3-6 .
You should install the metal plate for fixation to the controller with M4 x 8 or the shorter
screw. The screw projection length inside the controller (side board thickness is 1.2 mm)
surely makes 6.8 mm or less.
When storing the controller in a cabinet, etc., take special care to the heat radiating
properties and ventilation properties so that the ambient temperature remains within the
specification values. And, don't install the controller in the position where direct rays or
the heat of lighting hits. The skin temperature of the controller may rise, and the error
may occur.
㻴㼛㼞㼕㼦㼛㼚㼠㼍㼘㻌㼕㼚㼟㼠㼍㼘㼘㼍㼠㼕㼛㼚
㼂㼑㼞㼠㼕㼏㼍㼘㻌㼕㼚㼟㼠㼍㼘㼘㼍㼠㼕㼛㼚
㻝㻠㻡㼙㼙
㻭㼕㼞㻌㼕㼚㼠㼍㼗㼑
㻭㼕㼞㻌㼕㼚㼠㼍㼗㼑
㻝㻣㻜㼙㼙 㻝㻡㻜㼙㼙
㻞㻜㼙㼙
㻡㻜㼙㼙
㻝㻡㻜㼙㼙
㻝㻠㻡㼙㼙
㻝㻡㻜㼙㼙
CAUTION
CAUTION