Mitsubishi Electric AnyWire NZ2AW1C2AL, User Manual

Page: 98 / 126

96
9 TRANSMISSION TIME
9.2 AnyWireASLINK Transmission Time
AnyWireASLINK

slave module (output)
The figure below shows the time between the CPU module device turning on/off and a signal output of the bridge module
turning on/off.
Calculation formula
1) processing time of the bridge 2) transmission time + 3) processing time of the slave 4) output response
time of the slave module
Parameter access response time
The parameters of AnyWireASLINK provide monitoring information of slave modules or the entire system and setting
information of the slave modules.
Parameter data is synchronized between the bridge module and slave modules at a cycle different from that of I/O data.
Use the following calculation formulas to obtain the parameter access response time.
No. Description Required time
1) Processing time of the bridge
module 0.6ms
2) Transmission time Transmission cycle time

2
The transmission cycle time differs depending on the number of transmission points.
(
 Page 94 Transmission cycle time of the bridge module)
3) Processing time of the slave
module Approx. 0.04ms (The time differs depending on the slave module.)
4) Output response time on the slave
module Refer to the manual for the slave module connected to the system or the device connected to the slave module.
Item Calculation formula
Update interval time of automatically updated parameters Number of AnyWireASLINK connected IDs

Transmission cycle time

3
Time required for reading parameters Number of target IDs

Transmission cycle time

27
Time required for writing parameters Number of target IDs

Transmission cycle time

39
Slave module
AnyWireASLINK
Output
4) Processing time of the
bridge module
2) Transmission time
4) Output response time
of the slave module
Input from the
CC-Link side
3) Processing time of the
slave module