Mitsubishi Electric 3F-14C-WINE, User Manual

Page: 367 / 646

15-367 15-367
15.5. Robot controller security function (Password Setup)
It is possible to forbid access to the robot programs, parameters, and files in the robot controller.
The security function can be achieved by setting a password in the robot controller. The robot controller software
versions where this can be used are as follows.
Table 15-12 Compliant version of this function and controller
Robot Controller Software version
CR800-D/CR800-R/CR800-Q All versions
CR750-D/CRnD-700 series Ver.S3 or later
CR750-Q/CRnQ-700 series Ver.R3 or later
CRn-500 series Unavailable
The functions where a password can be set are as follows. It is possible to individually set and release
passwords for access to programs, parameters, and files. The factory default setting of "Password Setup" is “off”.
Table 15-13 Function that access is limited.
Type Limited functions Remarks
Program
・
Writing the programs.
・
Reading the programs.
・
Copying the programs.
・
Renaming the programs.
・
Deleting the programs.
・
Writing the position data for SQ Direct.
・
Reading the position data for SQ Direct.
･
Initialization of robot programs.
･
File Manager
It is not possible to delete or rename the
file.
Parameter ・
Writing the parameters.
It is possible to read the parameters
from the robot controller.
・
Position repair function.
It is not possible to write the revision
parameter created by “Position repair
function” in the robot controller.
･
Restore the origin backup data.
･
Restoring the program information
File
・
Backup
・
Restore
・
Position repair function
Perform registration, change, and the deletion of the password while connected to the robot controller. From the
project tree double-click the target project [Online] -> [Maintenance] -> [Password Setup].