Mitsubishi Electric 3F-14C-WINE, User Manual

Page: 151 / 646

11-151 11-151
11.7.4.10. Jump to label / p rocedure definition line
If you left-click while holding down the [Ctrl] key for the label name or the procedure name of the instruction editing
area, jump to the corresponding definition line.
The robot program language corresponding to this function is as follows.
Table 11-4 Job correspondence table for robot program language
Program Language Label p rocedure
MELFA-BASIC VI
○ ○
MELFA-BASIC V
○
×
MELFA-BASIC IV
○
×
Movemaster commands × ×
○: Enable ×: Disable
Figure 11-47 Jump screen to label definition line
11.7.4.11. Partial writing
Writes the selected program lines to the robot controller.
This is handy for reflecting the contents of a partially revised program in the robot controller. But be careful, only the
selected part of the program is written.
Select the line to write to the robot controller, and click the [Edit] tab -> [Transmission] group -> [Partially] button on
the ribbon.
Check the contents to be written, and then click [Yes].
Figure 11-48 Partial Writing
Jump to definition line
[Ctrl] + Left-click