Cabinet
Panels
included.
Hardware
included.
Required
Tools.
Handy
Tools.
Manufactured in New Zealand for: Mitre 10 New Zealand Limited.
Bottom Panel x1
10.5mm Drawer
Scr
ew ( 24 )
Back Panel x1
Side Panels x2
Rail Panel x1
Drawer Base Panel x3
SCREWS
POWER DRILL
CLAMP
LEVEL
TAPE
MEASURE
PENCIL
LADDER
DOWELS
( 16 )
LEG BASES
( 4 )
ADJ. LEGS
( 4 )
KICK CLIP
( 2 )
DRAWER BACKS
( 3 )
GALLERY RAIL SETS
( 2 )
DRAWER
SETS
( 3 )
FOOT
( 4 )
CONNECTOR
SCREWS
( 2 )
PZ2 BIT
5MM
DRILL BIT
RUBBER
MALLET
SCREWDRIVER
Installing Leg Bases.
Fixing Bottom and Back Panel.
Inserting Dowels
into Side Panels
1.
2.
3.
Note:
Position leg base as shown
in the image to support side panel.
• Fix the Leg bases by aligning them on the base panel as shown.
• Ensure dowels in the leg bases line up with the holes. Use a block of wood
between leg base and mallet to prevent damage before striking it into place.
• Lay the back down flat as shown.
• Use 50mm Cabinet Screws to fix the bottom panel to the back panel.
• While laying the panels flat, insert
the dowels into the correct holes as
marked in the image shown.
BASE CABINET
3 DRAWER UNIT
Assembly Instructions
Suitable for Base Cabinet
BD60D2P-IMP, BD80D2P-IMP,
BD90D2P-IMP
732.25.817
50mm Cabinet scr
ew A ( 15 ), B ( 16 )
15mm Cabinet
scr
ew ( 36 )
29mm counter sunk
scr
ew ( 2 )
TOP FIXING
BRACKET
( 2 )
Handy Note:
Please read the instructions carefully before you start and make sure to identify the parts you need for each step.
When assembling it is best to do on a soft surface to prevent damage.
Note:
Connector screws are
used to connect two carcase
units together. 5mm through
holes are provided on some
of the front edges of the side
panels to connect adjacent
carcase.
Legend
A. = BD60D2P-IMP
B. = BD80D2P-IMP
BD90D2P-IMP
( 4 ) 16mm Drawer Fr
ont Scr
ew