760BPX Premium
Original Instructions Version June 16
760BPX_2805161
18
3.2 Adjusting the Speed
Rotor rpm must be proportionate to the type of work and regulated by the throttle trigger (9)
located on the upper handgrip. The throttle trigger can be held in any required position
using the throttle setting device (8).
3.3 Stopping the Engine
To stop the engine:
– Turn the throttle setting device counterclockwise to the O position (fig. 9).
– Release the throttle trigger, allow the engine to run at idle for 10 seconds.
– Turn the throttle setting device counterclockwise to the end (fig. 9).
4. Operating the Blower
The Engine speed should be adjusted to the type of material to be
removed, it is seldom necessary to use full throttle,and many work
procedures can be done at half throttle:
– If necessary, dampen the surface to be cleaned in order to
avoid creating too much dust
– Use the engine at low speed for lightweight material
– Use the engine at average speed to move grass and lightweight
leaves on pavement or solid ground
– Use the engine at high speed for heavier materials like fresh snow or voluminous dirt
– Use a rake or a brush to release rubbish stuck to the ground.
– Hold the opening of the blower as close to the ground as possible. Utilise the entire length of
the blow pipe to keep the air current close to the ground.
Always pay the utmost attention to prevent removed material or dust from injuring
people or animals or damaging property. Always assess the wind direction and never
work against the wind.
