13
Original Instructions Version May 16
280BVX/260BX_130516
3
IMPORTANT
To avoid breaking the starter rope, do not pull the whole length of it or let it slide
along the edge of the rope guide hole. Release the starter gradually, to avoid letting it fly back
uncontrollably.
5. Switch the lever (2) to the «RUN» position.
6. Pull the starter rope again until the engine starts, and press the throttle trigger all the way (4)
until the engine starts as normal.
7. When the engine has started, press and release the throttle trigger (4) to allow the engine to
idle.
8. Rev the engine a little and allow the engine to warm up for a few minutes before using the
machine.
IMPORTANT
If the starter rope is pulled repeatedly with the choke on, it may flood the engine
and make starting difficult. If ou happen to flood the engine, repeat the hot start procedure a
few times to eliminate any excess fuel.
3.1.2 Hot starting
To hot start the engine immediately after it has stopped, follow steps 2 - 3 - 4 - 6 of the above
procedure, making sure the primer (3) is activated 2-3 times only.
3.2 ADJUSTING THE SPEED (Fig. 4)
Rotor rpm must be proportionate to the type of work and regulated by the throttle trigger (4)
located on the upper hand grip. The throttle trigger can be held in any required position by en-
gaging the throttle setting device (5).
3.3 STOPPING THE ENGINE (Fig. 4)
To stop the engine:
– Turn the throttle setting device downwards (5)
– Release the throttle trigger (4)
– Press and hold the switch (1) in the «O» position until the engine switches off, then release
the switch which will automatically move to the «I» position ready for the next start procedure
260BX Premium Blower
280BVX Premium Blower/Vacuum
