Mitel TA7108, Hardware Installation

Page: 21 / 30

TA7104 /7108 Hardware Installation
155/1531-ANF 90114 C 2017-03-08 18
5 APPENDIX A – STANDARD COMPLIANCE AND
SAFETY INFORMATION
This Appendix lists the various standards compliance of the TA7104/7108.
Category Specification
Agency approvals
• European Union, CE mark (Declaration of Conformity)
Safety standards
• UL60950-1: 2
nd
Edition, 2007-03-27
• CAN/CSA-C22.2 No. 60950-1- 07 2 nd
Edition, 2007
• IEC 60950-1: 2005, 2 nd
Edition with all national deviations
•
Emissions
• EN61000-3-2 (1995) Harmonic current emissions
• EN61000-3-3 (1995) Voltage fluctuations and flicker (with amendment
A1)
Immunity EN55024:1998 with amendments A1 (2001) and A2 (2003) including the
following:
• EN61000-4-2 (1995), ESD
• EN61000-4-3 (1996), Radiated RF
• EN61000-4-4 (1995), Burst Transients
• EN61000-4-5 (1995), Surge
• EN61000-4-6 (1996), Conducted RF
• EN61000-4-11 (1995), Voltage Dips and Interruptions
Note: The standards compliance of the TA7104/7108 are printed on a sticker located on the bottom of
the unit.
5.1 DISCLAIMERS
The following are the disclaimers related to the TA7104/7108.
Federal Communications Commission (FCC) Part 15
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help
Note: Any changes or modifications not expressly approved Mitel
could void the user’s authority to
operate the equipment.
Notice to European customers: