Mitel SX-200 ICP - 1.0 5020, Technician'S Handbook

Page: 74 / 360

66
SX-200 ICP CX/CXi Technician’s Handbook
2. In the server application,
- Create a User for password-protected logins or allow Anonymous
(no password required) logins.
The default database is programmed to allow Anonymous logins.
The default user name is FTP.
- Set up the paths to the directories you created in step 1.
- Enable read/write access to directories.
3. If required, restart the server.
System Health Check
Complete the following procedure to verify that the system is working
properly.
1. Press Superkey followed by the prime line/intercom key (bottom key,
or bottom-right key when the phone has two rows of personal keys).
The extension number appears in the phone display. Record the
extension numbers.
2. Verify that you can make calls between the IP phones.
3. If an analog phone is connected to an ONS port (extensions 201 to
203) on the controller, verify that you can call it from an IP phone.
4. Place a call into the system and verify that the call rings all IP phones
as they should with the default key system configuration.
5. Verify that you can place an external call from the IP phones.
6. If you cannot perform all of the above tasks, check your cable
connections. If the problem persists, see
Basic Troubleshooting and
Repair (p. 211) .
7. Proceed to Chapter 3, Basic Programming.
Note: To verify that the FTP Server works, log into it from the PC. Go to the
CMD prompt (DOS) and enter ftp < IP Address of the FTP Server >. Look
for the message “Anonymous user logged in” or a prompt to enter a user
name.
Note: If you are not using the default database, you must program ARS to
access an outside line.