Mitel SX-200 ICP - 1.0 5020, Technician'S Handbook

Page: 114 / 360

106
SX-200 ICP CX/CXi Technician’s Handbook
Programming Analog Trunks
Non Dial-In Trunks
1. Form 01, System Configuration
- Program a trunk card that meets the trunk type requirements.
2. Form 13, Trunk Circuit Descriptor
- Create a trunk circuit descriptor that corresponds to the type of
trunk that you are programming. A circuit descriptor for the
LS/CLASS trunks is already programmed in the default database;
see page 296 for the settings.
3. Form 03, Class of Service
- Assign trunk options only.
4. Form 14, Non-Dial-in Trunks
- Assign COS and Tenant.
- Assign the directory number or an abbreviated dial number which
incoming calls will ring for Day Service, Night Service 1 and 2
modes.
- Assign a Circuit Descriptor Number (links this form to Form 13).
- Assign a Trunk Name if desired. This name appears on the set
displays for incoming and outgoing calls.
- Assign a Trunk Number in the range 1 to 200.
5. Form 16, Trunk Groups
- Assign to a trunk group if outgoing.
Programming a range of Non Dial-in Trunks
The RANGE PRGRM softkey allows block programming of trunks on the
same card. You must program the first trunk in the range and then press
RANGE PRGM to copy the values to the range of trunks that you specify.
The following fields are copied from the first trunk in the range:
COS, TEN, DAY, N1, N2, CDN
The TK NAME and COMMENTS fields are left blank.