Programming
131
Pro
gramming
Programming the PMS Interface
1. Determine the customer’s PMS communications protocol require-
ments: baud rate, parity, character length, and number of stop bits.
2. Form 11, Circuit Descriptor
n
Program to match the protocol.
n
Select the Circuit Descriptor Options.
.
Option Name
Value
Session Inactivity Timer
0
Guard Timer
2
Minimum Baud Rate
match customer’s PMS
Default Baud Rate
match customer’s PMS
Maximum Baud Rate
match customer’s PMS
Always use Default Baud Rate when called
YES
DTR Off Disconnect Timer
5
DTR to CTS Delay Timer
100
DTR Forced High
YES
RTS Forced High
YES
DSR Is held High when device is Idle
YES
CTS Is held High when device is Idle
YES
Originate a DTRX Call with Low - High transition of DTR
NO
Action taken if the Idle DTE has DTR Low ( Auto-Answer )
REFUSE
ASYNC: Keyboard Origination Allowed ( Auto Baud)
DISABLE
ASYNC: ADL Auto Baud
DISABLE
ASYNC: Flow Control
XON/XOFF
ASYNC:Break Key Function
Transparent
ASYNC: PBX Attention Character
0
ASYNC: Parity
match customer’s PMS
ASYNC: Character Length
match customer’s PMS
ASYNC: Number Of Stop Bits
match customer’s PMS
DS2100: Operating Mode
ASYNCHRONOUS
If you make changes to a Dataset’s Circuit Descriptor after it is
powered-up you must power down then power up the Dataset
for the changes to take effect.
Summary of Contents for SX-200 EL
