Mitel SX-200 EL, Technician'S Handbook

Page: 138 / 262

Technician’s Handbook
128
9. Press Enter until the [VxWorks Boot] prompt appears.
10. Type ‘@’.
11. After the Critical Alarm LED goes off, reconnect the Ethernet cable.
CDE Programming for the SX-200 IP Node
1. Form 01 - System Configuration
n
Assign IP Line Cards to slots.
2. Form 04 - System Options
n
Assign the BCC III Card to the IP Signalling Bay
—
Option 116, IP Signalling Bay (1-7) number
—
Option 117, IP Signalling Bay IP Address
—
Option 118, IP Signalling Bay Gateway Address
—
Option 119, IP Signalling Bay Subnet Mask
3. Form 47 - IP & DCHP Parameters
n
Enter the IP Controller Address. Enter the SX-200 IP Node
address.
n
Enter the DHCP Server Subnet.
n
Enter the DHCP Server Subnet mask.
n
Enter the DHCP Assignable IP Address Start. Enter the start
range of the IP phones.
n
Enter the DHCP Assignable IP Address End. Enter the end
range of the IP phones.
n
Enter the TFTP Server Address. Enter the IP address of any
SX-200 IP Node.
n
Enter the Gateway/Router IP Address.
n
Leave blank the Mitel Only field.
n
Enter the VLAN ID (optional). Enter a unique ID between 1 and
4095 for the dual-port IP phones.
n
Enter the IP phone Priority. Use a priority of 7 (highest).