Mitel SX-200 EL, Technician'S Handbook

Page: 137 / 262

Programming
127
Pro
gramming
n
Program the option “CLASS Trunk” in the circuit descriptor
options subform for the appropriate 4 or 8-circuit CLASS trunk.
5. Form 14, Non-Dial-In Trunks or Form 15, Dial-in Trunks
n
Program the CLASS trunks.
6. Form 04, System Options and Timers
n
Program the CLASS receivers for the LS/CLASS Trunk module.
The LS/CLASS Trunk card provides its own CLASS receivers
and does not require programming in Form 04.
Programming an SX-200 IP Node
Initializing the SX-200 IP Node
1. Ensure the SX-200 IP Node is not connected to a power source.
1. Disconnect the the Ethernet cable from the Ethernet port on the
SX-200 IP Node.
2. Using a serial cable, connect a PC to the Maintenance Port on the
IP Node.
3. Launch a data communication application, such as Hyperterminal
on the PC.
4. Set the parameters: 9600, 8, N, 1, None.
5. Plug in the SX-200 IP Node to a power source.
6. At the “Press any key to stop and auto-boot” prompt, press any key.
7. At the [VxWorks Boot] prompt, type ‘c’.
8. Press Enter to type data in the following fields:
n
inet on ethernet (e): IP address of the SX-200 IP Node
n
gateway inet (g): IP address of the WAN gateway or router
In Form 15 the CLASS trunk becomes a DISA trunk.