Technician’s Handbook
126
Programming a CLASS Trunk
1. Form 01, System Configuration
n
Program the LS/CLASS Trunk module or the LS/CLASS Trunk card.
2. Form 03, Class of Service, Define for trunks.
n
To have Calling Line ID digits reported in the SMDR records, enable
COS Option 806 (SMDR-Record Incoming Calls) and COS Option
814 (SMDR-Record ANI/DNIS/CLASS). Enable COS Option 702
(SMDR - Overwrite Buffer).
n
To have CLASS name reported in the SMDR records, enable COS
Option 246 (SMDR-Extended Record) and COS Option 814
(SMDR-Record ANI/DNIS/CLASS).
3. Form 03, Class of Service, Define for SUPERSET sets.
n
To display Calling Line ID digits on a SUPERSET display set or
console, enable COS Option 502 (Display ANI/DNIS/CLASS
Information) in the class of service for the set/console. Enable COS
Option 613 - Display ANI Information Only if required.
n
To display CLASS name before Calling Line ID digits on a
SUPERSET small display set (SUPERSET 4025, SUPERSET
4125, or SUPERSET 420 telephones), enable COS Option 503
(Display CLASS Name) in the class of service for the set.
4. Form 13, Trunk Circuit Descriptor
n
Assign the CLASS trunk with the circuit descriptor. An LS/CLASS
Trunk module uses “4-CIRCUIT CLASS ”. An LS/CLASS Trunk card
uses “8-CIRCUIT CLASS“
Programming a LS/CLASS Trunk card requires
LIGHTWARE 19 Release 2.0 or greater software.
Assign a separate COS for the trunk.
Summary of Contents for SX-200 EL
