Mitel SmarT-1 50000241, Installation And Programming Manual

Page: 41 / 90

Line and Trunk Options
8380-383-115-BA
Issue 1, February 1999
40
CHAPTER 8
8. Line And Trunk Options
8. 1. General
Line and Trunk refer to the physical line that is supplied by your PSTN. Route refers to the
way the SMarT-1 Dialer One-line Dialer will attempt to route the call through the Exchange
Line by using a set of predefined dialling rules (refer to Access Control Sequence).
All Line and Trunk entries have a predetermined length. When you enter the Line and Trunk
option (i.e. 100), followed by a one digit value, the Dialer will automatically accept the entry.
8. 2. 100 - Type of Exchange Line
This option controls whether the Dialer will dial loop start rotary or loop start MF4 to the
Exchange side of the Dialer
8. 3. 102 - MF4 Dialling Rate 1
This option controls the default rate at which MF4 digits are dialled to the Exchange side from
the Dialer. The default MF4 Dialling Rate may be changed by using ACS tokens in the 6R5
Registers, which consult the R60/R80 (refer to page 69) and the R61/R81(refer to page 70)
Registers.
Register Default Description
100 T 2
T = 0 Loop Start, Rotary
T = 2 Loop Start, MF4
Register Default Description
102 T 4
T = 3 for 70 ms (fast)
✳
for 140 ms
T = 4 for 80 ms # for 150 ms
T = 5 for 90 ms C for 160 ms
T = 6 for 100 ms D for 170 ms
T = 7 for 110 ms E for 180 ms
T = 8 for 120 ms F for 190 ms (slow)