Mitel SmarT-1 50000241, Installation And Programming Manual

Page: 60 / 90

Callback
8380-383-115-BA
59 Issue 1, February 1999
Callback Disconnect Sequence
The Dialer has the ability to send terminating characters, for instance an MF4 #, to clear the
local PTT line after a routed call has been made. After the user hangs up the telephone, the PTT
line will be disconnected for the time specified by the 103 register (On-hook Timing). The PTT
line will then be reseized, and the terminating characters will be dialled.
Any of the tokens that are listed in the following table may be used to access the terminating
characters or used as terminating characters.
10. 1. 2. Example
• 625 #562279
#562 wait for 200 ms of 425 Hz dial tone, for up to four seconds
2 dial destination number
7 through connect
9 dial the contents of 6R4 after the phone is hung up.
Tokens and their Definitions
0 for dial a 0
1 for dial a 1
2 for dial the destination number (up to 106 digits)
3 for dial the Route Access Code (Register 6r1)
4 for dial the Authorisation Number (Register 6r2)
5 for dial the Cost Centre Code (up to 22 digits)
8 for change to MF4 dialling
9 for dial contents of Register 6r4
✳ ✳ ✳ ✳
7 for dial the contents of Register 6r7
✳
✳ ✳
✳
8 for dial the contents of Register 6r8
✳ ✳ ✳ ✳
9 for dial the contents of Register 6r9
#0
✳
✳ ✳
✳
for dial a
✳
(MF4)
#00 for dial a # (MF4)
#01 for dial a # if the last digit dialled out was not a #
#06 for dial the PABX/Centrex select digits buffer
#07 for dial the Primary select digits buffer
#08 for dial the Alternate select digits buffer