Mitel SmarT-1 380-003-FBCLXX, Installation And Programming Manual

Page: 21 / 94

Initialisation
8380-383-115-BA
Issue 2, June 1999
20
CHAPTER 4
4. Initialisation
Before you can program the SMarT-1 EuroRoute One-line Dialer for the first time, you must
initialise the unit. Initialisation can only be done by using an MF4 telephone.
4. 1. Initialisation
1. Connect an MF4 instrument to the FAX side of the Dialer. There must be a PABX/Centrex
Line port, simulated PABX/Centrex Line port or an Exchange Line present on the Line side
of the Dialer
2. With the power to the Dialer disconnected, go off-hook. While holding down the
✳
key on the MF4 set you will hear a continuous tone. Reconnect the power to the Dialer
When the power is applied, there will be a “click” sound heard from the Dialer as it
disconnects (splits) from the PABX/Centrex or Exchange Line side.
3. Continue to hold the
✳
key for 20 seconds or more after applying power to the Dialer (See
Note below).
4. Release the
✳
key. The unit should respond immediately with a short
from the handset.
There could be
, depending on the previous Dialer condition. If is not heard, return to
Step 2 and start over. The tone indicates that the Dialer is initialised and remains in
programming mode.
Inactivity in programming mode for more than two minutes will automatically exit
programming mode without saving any changes. There will be
after 60 seconds of
inactivity in programming.
5. Enter 942 and you will hear
. Enter 918 and you will hear . Enter X (variable for the
country-specific defaults) and you will hear
.(refer to page 31 for more details)
X = 0 for EuroRoute X = 4 for France
X = 1 for UK X = 5 for Netherlands
X = 2 for Italy X = 6 for Germany
X = 3 for Spain X = 7 for Portugal
6. To exit programming mode dial 987, then go on-hook.
7. Do not disconnect the power from the Dialer, until at least 10 seconds have expired after
exiting programming mode. During this period, any programming in the Dialer is being
stored into the Dialer’s nonvolatile memory. Disconnecting the power prematurely will
result in a loss of programming, and a checksum error (Refer to page 12).
Note: When you press the
✳
key, and IF YOU HEAR reorder tone from the PABX/Centrex,
Exchange Line or the CPE, the telephone may be connected to the wrong side of the Dialer.