Mitel MIVOICE OFFICE 250, Installation And Administration Manual

Page: 471 / 585

Network IP Topology
443
Table 74: Port Assignments
Type
Default Ports and
Protocol
Comments for Firewall
Voice Over IP 6004–7038/UDP(RTP)
6005–7039/UDP(RTCP)
Enable only if using VoIP outside the firewall.
Inter-Tel Protocol (ITP) 5566/TCP(ITP Call Control)
5567/UDP(ITP Call Control)
Enable only if using ITP IP phones outside the
firewall. Phones that use ITP include the 86xx IP
phones and IP-SLA.
SIP 5060/UDP Enable only if using SIP phones, trunks, or
gateways outside the firewall.
MGCP 2427/UDP Enable only if using MGCP trunks outside the
firewall.
Private Networking
a
5570/TCP The MiVoice Office 250 uses this port for inter-node
communication. This protocol does not support
NAT on either side. Private Networking over IP will
not work through a firewall with NAT enabled.
Administration/Applications — Unsecured (prior to v4.0)
• DB Programming
• OAI
• Diagnostic Monitor
• System Manager 4000/TCP The MiVoice Office 250 uses these ports for system
administration, diagnostics, applications, and
upgrades. Enable only if necessary for external
communications through the firewall.
• OAI Broadcast 4000/UDP
• Web Interface 80/TCP(HTTP)
Administration/Applications — Secured (v4.0 and later)
• System Administration &
Diagnostics
• OAI
• DB Programming
• Message Print
• System Monitor
44000/TCP The MiVoice Office 250 uses these ports for system
administration, diagnostics, applications, and
upgrades. Enable only if necessary for external
communications through the firewall.
• Web Interface 443/TCP(HTTPS)
Diagnostics
• Diagnostics Web
Interface
80/TCP(HTTP) Enable only if directed by Mitel support personnel.
(AVDAP Monitor is used for certain voice mail
diagnostics. Secure Shell is used for system
diagnostics and communication between the Base
Server and the Processing Server.)
• AVDAP Monitor 4444/TCP
• Secure Shell 22/TCP(SSH)
Voice Mail 25/TCP(SMTP) The MiVoice Office 250 uses SMTP to receive
VPIM messages.
(Sheet 1 of 2)