Mitel MIVOICE OFFICE 250, Installation And Administration Manual

Page: 303 / 585

Installation
275
To wall-mount Mitel 8600 series phones with release buttons on the bottom housing:
1. Close the base completely so that it lies flat against the phone. (Rivet hole 1 on the base aligns
with the rivet hole on the bottom housing of the phone.)
2.
Plug the four-inch line cord into the jack on the back of the phone and thread the line cord
through the wall-mount knockout on the base.
3.
Insert one of the plastic rivets in rivet hole 1 on the base (see the illustration above) and press
it into the rivet hole on the phone. This locks the base to the phone.
4.
Test the base to verify that it is securely locked to the phone.
5. Reattach the metal plate to the phone base.
6.
Insert the remaining plastic rivet through rivet hole 3 (as shown at
right) in the metal plate and press it firmly into rivet hole 2 in the base.
This locks the metal plate to the base.
7. Plug the line cord into the jack on the wall-mount bracket and position
the phone securely on the wall-mount bracket.
8. Flip the handset hanger down to the horizontal position and lock it into
place. This holds the handset in place.
Changing Protocol Modes: IP and SIP
The Mitel 8600, 8620/8622, 8662, and 8690 multi-protocol phones support Internet Protocol (IP) or
Session Initiation Protocol (SIP) mode. Details about each of the modes are described in the
Specifications chapter. For complete information about supported features, buttons, and
light-emitting diode (LED) indications for multi-protocol phones in IP or SIP mode, see the
Multi-Protocol Phones: Supported Features, Buttons, and LED Indications
document, part number
835.2840.
NOTE
86xx multi-protocol phones in SIP mode are not supported on the MiVoice Office
250 platform.
Rivet Hole
Base
Rivet Hole 1
Release Buttons
Bottom Housing
Rivet Hole 2
(Base not shown)
(Used to lock base (Used to lock metal
plate to base) to bottom housing)
Rivet Hole 3
Metal Plate