Mitel MIVOICE OFFICE 250, Installation And Administration Manual, Page: 108 / 585

MiVoice Office 250 Installation and Administration Guide
80
the battery is adequately charged. When the LED lights green, the battery is recharging. For
instructions on replacing this battery, see “Replacing the Processor Module Battery” on
page 250.
• LED indicators : Shows main processor operation and module removal indicators.
• IP Port (100Base-T) : An auto-sensing (10/100 Mbps) eight-pin RJ-45 jack provides IP connec -
tion directly to the system with CAT5 or CAT5e cable. In addition, the IP Port can be used to
load Call Processing software or software licenses, or to program the database.
This port is configured to auto-negotiate both speed and duplex mode. As such, the network
switch port connected to this jack must also be configured to auto-negotiate speed and duplex
mode.
The LED on the right side of the RJ-45 jack is a link/activity LED. This LED is lit if the system
detects a physical network link, and it flashes if the system detects activity on the link. The LED
on the left side of the RJ-45 jack indicates the speed of the connection. This LED is lit if the link
speed is 100 Mbps, and it is unlit if the link speed is 10 Mbps.
• Software Security and Feature Program : Supports a software license that enables system
functionality. For details about the software security and feature program, refer to the
MiVoice
Office 250 Features and Programming Guide
.
• Caller ID receivers : Provides four resources for receiving Caller ID.
The PM-1 supports Call Processing across networks. Supports the United States and European
versions of MiVoice Office 250 software.
Interfaces on Front of the CS Controller
The front of the CS Controller Base Server chassis is equipped with a two-line LCD panel, an LCD
control consisting of four triangular buttons surrounding a circular button, two USB jacks, a Security
Key socket, a recessed compact flash ejection button, and a compact flash-type card bay.
LCD Panel : The LCD panel displays system status and command messages on two lines of 14
characters each. provides two basic functions. It displays system status information that the
technician uses to determine the operating condition of the system. As driven by five LCD control
buttons, the panel displays menus and options for programming, changing, or resetting the system.
LCD Control Buttons : The control buttons allow the technician to scroll through menu items to set
system parameters during system installation and to perform other system routines. The up and
down arrow-shaped buttons control the movement of the menus and menu items displayed on the
LCD panel. The up–down arrows also allow the technician to advance or retreat through letters or
numbers. The right and left arrow buttons control the movement of the cursor from one character
or command to another. Pressing the center, circular button causes the system to select and accept
the chosen letter, number, or command item.
NOTICE
NOTICE
Security is the customer’s responsibility. Mitel is not responsible for network problems due to
security violations involving the IP address exposure of the PM-1. This includes, but is not limited
to, interrupted network service. Mitel recommends that the customer install the MiVoice Office 250
in a private IP network behind a firewall or Network Address Translation (NAT) unit.