Mitel Inter-Tel Axxess, Administrator'S Manual, Page: 233 / 384

Page 217 Transfer-To-Connect Station Flag
System Features
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
TRANSFER-TO-CONNECT STATION FLAG
If the Transfer-To-Connect Allowed station flag is enabled, an announced transfer call (includ-
ing an announced transfer from Voice Mail) connects immediately with the destination once
the transferring party hangs up. (If the flag is disabled, the recipient must press a Call button or
the
button to answer the transferred call). If the user has a headset enabled, or if the
station user picks up the handset for the initial call and the transferring party disconnects, the
transferred party will hear a single tone and then be immediately connected without any further
action from the station user. (Calls will not automatically connect in handsfree speakerphone
mode.) This flag applies only to Inter-Tel endpoints and is disabled by default.
TRANSFER TO RING
To transfer a call or conference:
1.
Inter-Tel Endpoints: While on a call, press the button, or press the Special
button and enter the Transfer to Ring feature code (345). You hear intercom dial tone.
The display shows TRANSFER CALL TO EXTENSION.
Single-Line Sets: While on a call, hookflash/recall. You hear tones followed by inter-
com dial tone.
2.
EITHER, Select an outgoing trunk group or press the OUTSIDE PHONE menu button,
and dial the desired telephone number. If all trunks in the trunk group are busy, select
another trunk group or camp on and wait for a trunk. If you hear repeating reorder
tones, you dialed a restricted telephone number. To return to the caller on transfer hold,
press the lit Call button, trunk button, or button (Inter-Tel endpoint) or hook-
flash/recall twice (single-line set).
OR, Dial the desired extension number or press a speed-dial button, the
VOICE MAIL
menu button, or the
MESSAGE CENTER
menu button. Executive Display, Profes-
sional Display, and Model 8560 endpoint users can use the Directory feature by press-
ing the
IC DIRECTORY
menu button. The number can be a station extension number,
for the Attendant, a hunt group pilot number, a Voice Mail extension number, or a
transfer-to-park location number.
•
Transfer to a station that is forwarded to Voice Mail: You hear repeating dou-
ble tones and the display shows DEST FORWARDED TO VOICE MAIL.
•
Transfer to Voice Mail: The system waits for you to enter the mailbox number.
The display shows ENTER MAILBOX. Enter the desired mailbox number. (Exec-
utive Display, Professional Display, and Model 8560 endpoint users can use the
Directory feature by pressing the
IC DIRECTORY menu button, if the system is
validating mailbox numbers.) If you do not enter a mailbox number before you
hang up, the caller will be connected to the Voice Mail unit and must enter the
mailbox number after listening to the introductory voice prompts.
3.
If desired, wait for an answer and announce the call. If you are calling a device (such as
Automated Attendant) that does not accept call announcements, the display shows
HANG UP TO FINISH TRANSFER.
ANSWER
TRANSFER
IC
0