Mitel INT4000, User Manual, Page: 34 / 62

Answering and Placing Calls
Page 22
Mitel ® INT4000 User Guide – Issue 6, December 2008
Displaying Information on Your Endpoint
Your INT4000 has two lines of display where you can view information, such as the date and
time or the external party’s name and number.
Date, Time, Name, and Extension Number
You can temporarily display the system date and time, your username, and your extension
number at any time.
To show the date and time display (while on a call, in DND, etc.):
Press and .
External Party’s Name and Number
If you are currently connected to an external caller with Caller ID, you can toggle between
displaying the caller’s name and number.
To show the external party’s name and number:
Press and .
Using a Headset
With an electret headset, you can talk on the endpoint handsfree, without using your speaker
and microphone.
To connect a headset:
1. Insert the headset plug into the vacant handset jack.
2. Enter the Headset On feature code ( ) or the Headset On/Off feature code
( ). The display shows HEADSET MODE ON.
To disconnect a headset:
1. Plug the coiled handset cord into the vacant jack.
2. While on-hook, enter the Headset Off feature code ( ) or the Headset
On/Off feature code ( ). The display shows HEADSET MODE OFF.
SPCL 3 0 0
NOTE
If there is no external party name available, the display shows CANNOT ACCESS
FEATURE.
SPCL 3 7
9
NOTE
If your headset has a power-saver mode, make sure the System Administrator has
the Headset Connect Tone flag enabled in the telephone system. If this flag is not
enabled, you may miss the first few seconds of incoming calls.
3 1 5
3 1 7
3 1 6
3 1 7