2
1
In
1
Adjusting the Viewing Angle of the BB424
(Optional)
The stand on the BB424 supports two tilt angles so that you can adjust how the button box sits
on a desk. The stand is shipped in the low position. Use these instructions to change the tilt
angle.
Remove the Stand:
1.
Disconnect any cables from the back of the BB424.
2.
Grasp the BB424 base in one hand and the stand in the other.
3.
Pull the stand off the base until it unsnaps.
Connecting a Single BB424 to a Phone
Required Items:
l
Micro USB cable (included)
l
IP485g phone
Connect the BB424 to the Phone:
1.
The BB424 is shipped with the micro USB cable already plugged into the back of it. Ensure that it
is plugged in firmly.
2.
Thread the free end of the micro USB cable from the side of the BB424 stand through the side of
the IP485g phone stand. Plug the USB jack into the USB port on the rear of the IP485g phone.
After a few seconds, the BB424 powers on and runs through a series of system tests.
BB424
Quick Install Guide
Copyright © 2017 Mitel Networks Corporation. All Rights Reserved. The Mitel word and logo are trademarks of Mitel Networks Corporation.
Any reference to third-party trademarks is for reference only and Mitel makes no representation of ownership of these marks.
Part Number: 800-1891-10
4
1
1
2
2
3
Low angle
High angle
Replace the Stand:
1.
Rotate the stand 180 degrees. Seat the stand firmly in the hooks.
2.
Push the stand into the base until it snaps into place.
3.
Reattach cables.
