Welcome
6
•
Do not spray any type of cleaner directly on the phone’s screen.
•
Do not allow any liquid to run down the surface of the touchscreen and under the bezel.
•
If using a damp cloth, disconnect power to the phone before wiping the screen.
To clean your Mitel 6970 IP Conference phone’s touchscreen:
1. Disconnect power to your phone.
2. Retrieve a soft cloth, such as a microfiber cloth.
3. If necessary, dampen the cloth. For regular cleanings, a dry cloth is usually sufficient. For
stubborn build-up or for periodic deep cleanings, wet the cloth under a faucet and then wring
out until it is just damp.
4. Wipe the screen gently with the cloth making sure to not get any moisture in the sides of the
screen. You can also wipe down the entire phone to remove dirt and grime.
5. Allow your phone to completely dry after you are done cleaning. This should only take a few
minutes.
6. Reconnect power to your phone.
Protect your hearing
Your Mitel 6970 IP Conference Phone has a control for adjusting the volume of the speakerphone.
Keep the volume at a moderate level because continuous exposure to loud sounds can contribute
to hearing loss.
CAUTION:
Use of any type of cleaners, alcohol, ammonia, and/or hard or sharp objects can harm
the touchscreen surface and potentially cause transparent conductive film cracks in the screen.
Note:
Keeping your touchscreen clean and free of dirt and fingerprints on a regular basis extends
the life of your phone touchscreen.
