Mitel 6867i Premium, Administrator'S Manual

Page: 249 / 1042

Global SIP Settings
4-96
• sip Line
N
rtcp summary reports
• sip rtcp summary report collector
• sip Line
N
rtcp summary report collector
• sip rtcp summary report collector port
• sip Line
N
rtcp summary report collector port
LIMITATIONS
The following is a limitation when enabling RTCP summary reports on the phone:
• The call must be at least 5 seconds long in order to generate the RTCP extended reports.
CONFIGURING RTCP SUMMARY REPORTS
Use the following procedure to configure RTCP summary reports.
For specific parameters you can set in the configuration files, see Appendix A, the section,
“RTCP Summary Reports”
on
page A-40
.
AUTODIAL SETTINGS
The IP phones include a feature called “Autodial”. When you configure Autodial on an IP phone,
the phone automatically dials a pre-configured number whenever it is off-hook. Depending on
the configuration you specify, the Autodial functions as either a “
hotline
”, or as a “
warmline
,”
as follows:
•
Hotline (default)
: The IP phone immediately dials a preconfigured number when you lift
the handset.
•
Warmline
: The IP phone waits for a specified amount of time after you lift the handset
before dialing a pre-configured number. If you do not dial a number within the time allotted,
then the IP phone begins to dial the number.
By default, the Autodial feature functions as a hotline. If you want Autodial to function as a
warmline, you can use the Autodial “time-out” parameter to specify the length of time (in
seconds) the IP phone waits before dialing a pre-configured number.
Note:
The transport protocol used for RTCP summary reports is also configurable. Refer
to "Configurable Transport Protocol for SIP Services and RTCP Summary Reports‚" on
page 48 for more information.
CONFIGURATION FILES