Making Calls
115
•
If you are in
Speaker/Headset
audio mode, press
to switch between handsfree and
headset.
•
When the handset is on hook, press
to disconnect the call.
USING A HEADSET
The 6865i accepts analog and DHSG/EHS headsets through the modular RJ22/RJ45 port on
the back of the phone. Contact your telephone equipment retailer or distributor to purchase a
compatible headset.
VOLUME CONTROLS FOR THE HEADSET MICROPHONE
On the 6865i, there are three options for the headset microphone volume:
Low
,
Medium
, and
High
. For information about configuring the headset microphone volume, see
“Headset Mic
Volume”
on
page 35
.
MAKING AND RECEIVING CALLS USING A HEADSET
1.
Ensure that you have selected a headset audio mode (see
“Audio Mode”
on
page 34
.
2.
Turn the phone over and locate the headset jack marked
f
.
If you have a headset with an RJ9/RJ22 4-pin connector, insert the headset cord into the
jack until it clicks into place.
If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the plastic
headset jack adapter and then insert the cord into the jack until it clicks into place.
3.
Press the
key to obtain a dial tone or to answer an incoming call. Depending on the
audio mode selected from the Options List, a dial tone or an incoming call is received on
either the headset or the handsfree speakerphone.
4.
Press the
key to end the call.
Note:
When handsfree is on, the speaker light turns on.
Notes:
1.
The RJ22/R45 headset port is for headset use only. Plugging any other devices into
this port may cause damage to the phone andwill void your warranty.
2.
Customers should read and observe all safety recommendations contained in
headset operating guides when using any headset.
IP PHONE UI
Note:
See the
Mitel 6865i SIP IP Phone Installation Guide
for more information.
